1.The plasticity of wood plastic decking should be considered when laying wood-plastic floor. It is recommended to use the length of 2M-3M. The length of the hollow floor should not be greater than 3M.   2. Consider the expansion and contraction of wood-plastic flooring from the perspective of technology. The ends may vary in length during paving, so it is recommended to cut the ends at the same time after all paving in a construction area to keep the ends neat.   3. Staggered joints should be used when laying sinonwpc wood-plastic floors. The joint spacing between floors can be determined according to humidity and temperature during the paving process, and expansion joints should be left at appropriate positions.   4. When paving the floor, use buckles and screws for paving. There are card slots at both ends of the floor to facilitate the insertion of the buckles. Be sure to fix the accessories on the keel, and then insert the floor. Plastic fittings (or small stainless steel fittings) must be used to fix the slots between the two floors. After fixing the floor and the small plastic parts (or stainless steel parts), the workers are located on the opposite side of the board and push the edges of the board forcefully to fix the connection between the board slots, and finally screw the small holes in the middle of all the small plastic parts. .   5. When the buckle is fixed, the screws should be screwed into the vertical keel. A buckle is required on each keel, and the buckle is placed in the middle of the keel. After placing the buckle, firmly fasten the second board toward the buckle. Make the buckle and the floor card slot tightly combined.