Working principle of aeratorThe water aerator is a disc-shaped filter screen located at the end of the faucet. It is detachable and only needs to open or close the threaded end of the nozzle. It is designed to decompose the water flowing through the faucet into several small streams and introduce air into the stream at the same time. Aerator can also reduce faucet noise and splash.The aerator also compresses the water flow. The combination of air dilution water flow and conical opening can reduce the volume of water and have the feeling of high-pressure flow. This process saves water, and the water pressure does not decrease significantly. Saving water can save money, especially on the fuel you use to heat water. According to the U.S. Environmental Protection Agency, the high-efficiency faucet aerator can reduce the water flow of the faucet by 30%, chrome shower faucet helping you save water and heating costs.Type of aeratorThe faucet aerator consists of three main parts - filter screen, flow restrictor and mounting. The mounting is screwed to the faucet and the aerator gasket is used to prevent leakage. But not all water aerators are the same. Although most aerators have external threads, Bath faucet they also have internal threads. The standard faucet thread size is 15 / 16 inch external thread or 55 / 64 inch internal thread. Aerators are also available in different sizes and colors to accommodate a wide variety of faucets for owners.There are also standard aerators, which allow a flow of 2.2 gallons per minute, and high-efficiency faucet aerators with a maximum flow of 1.5 gallons per minute. According to the U.S. Environmental Protection Agency, installing a high-efficiency faucet aerator can save an average of 700 gallons of water a year for families, about the amount of water required for 45 showers. The average cost of these aerators is less than $10, which is well worth it. The only disadvantage is that an aerator with a low flow rate will significantly increase the time required to fill the sink or wash dishes.Replace the aeratorWater aerators usually prolong the service life of faucets, but like most mechanical parts, they also have problems. The most common problem is that the filter screen is blocked by sediment, reducing the amount of water in the faucet. This is usually the cause when the faucet begins to lose water pressure. To fix it, just unscrew the aerator from the end of the nozzle by hand, and then rinse or clean the filter screen with a small brush. You can also use an adjustable wrench or pliers to gently remove the aerator.If your ventilator needs to be replaced, you must find one that is compatible with your faucet. There are many sizes and styles of water aerators. diverter mixer chrome bath faucet It won't be difficult to find a faucet that suits you. Just unscrew the old aerator and screw on the new aerator, make sure to remove the old aerator gasket and use the new aerator gasket to provide a good seal. In most cases, the owner can replace the water aerator within a few minutes.